Mermade Hair Interchangeable Blow Dry hot air brush

Introducing the interchangeable blow-dry brush from Mermade. With one base and three heads, you can dry, straighten and style your hair with a single device. How it works: Dry the roots and excess water with the pre-styling attachment. Then choose your fighter. The oval volume head (2.3") creates epic curves and bounce for the ultimate salon-quality blowout. The round curl attachment (1.25") conjures up loose curls with ease. Thanks to the detachable attachment, it's the only tool you need to pack in your suitcase. The blowout of your dreams is just one appliance away.

• Flexible bristles
• Three heat settings
• 360° airflow
• 60 mm shaft
• Ionic technology
• Powerful - 125V~ 50-60Hz 1800W
• 2.5 m rotating cable
• Device warranty 2 years

How to use:

Step 1 Dry the hair with a towel so that it is damp. Slide the button upwards to switch on the appliance and select the desired settings. The red light indicates "ON". Dry the roots with the pre-styling attachment and remove excess water.

• Cool - cooling function, low power
• Low - high heat, low power
• Hot - high heat, high power

Styling tip: Prep your hair with a heat protectant every time you heat it. For added volume and control, use a styling mousse or root spray.

Step 2: Section the hair into 2-inch sections using our grip clips. Use the 60mm attachment to start with the lower sections. Place the 60mm oval brush near the hairline and brush slowly away from the head. Continue to remove moisture and dry each lower section. For added oomph, you can wrap the ends of the hair around the attachment to create a bouncy blowout look.

Step 3: For more defined curls, switch to the 32mm attachment. Wrap the hair around the attachment while pulling down and twisting the appliance at the same time. This will give you the curve and bounce you can only get in the salon.

Step 4 When you have dried your hair, slide the button down to 'OFF'. Set your blowout with hairspray for extra hold. Allow the interchangeable blow-dry brush to cool completely before removing and storing the heads.